First off I need to preface by saying I know little to nothing about
this stuff, however we use an NI card for side-scan sonar data
acquisition using Chesapeake Technologies.
We use a PCI-DIO32HS card that was installed and running fine in an
onlder Pentium III computer. I was in the process of bringing the
software and cards into a new Dell system, however some connections I
had ordered hadn't arrived, so I was attempting to reinstall the card
into the PIII computer and now it wont recognize the base address in
either computer. I have tried deleting the device in Measurements
and Automation, shutting down, removing the card, rebooting, and adding
the card again. I have tried the same technique in addition to
uninstalling and reinstalling the newest driver for the card (7.4.1)
downloaded from the net last night.
Installing (again) the card I get the same error under test resources "Device is not responded to the selected base address"