LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

relation between the IQ rate and carrier frequency

Solved!
Go to solution

Hi everyone:

the used software is:labview 2015.

the used hardware:two USRP_2932 ,tethered with MIMO Cable (each with Unique IP Addresses),each USRP is connected to laptop,one for transmission,and the other for reception.

my project is to transmit a text through one of the USRP and receiving it through the other USRP.

my question is:when I uses the configuration[(TX IQ Sampling Rate [s/sec]=2M),(TX Frequency =915M)] for both the transmitter and the receiver,the project working well.

But when I uses the configuration[(TX IQ Sampling Rate [s/sec]1.2M),(TX Frequency =2.2G)],the transmitter send the data but the receiver doesn't receive any thing of the a text.

so I want to know what is the relation between the two configuration(the relation between the IQ sampling rate and the carrier frequency).

thanks a lot.

0 Kudos
Message 1 of 2
(2,011 Views)
Solution
Accepted by topic author DOHAAACB19619

You should probably do some reading up on what, exactly, IQ data is.  IQ Data for Dummies is a good place to start.

Bill
CLD
(Mid-Level minion.)
My support system ensures that I don't look totally incompetent.
Proud to say that I've progressed beyond knowing just enough to be dangerous. I now know enough to know that I have no clue about anything at all.
Humble author of the CLAD Nugget.
0 Kudos
Message 2 of 2
(1,982 Views)