cRIO startup directory was typed STARTUP and now will not boot. How do I recover from this error or how do I rename the directory when my proxy server is read only due no startup files?

[lockmas]

I loaded files on the cRIO but used upper case letters for the startup directory.  Now I cannot access the RIO since it didn't boot. The proxy server comes up read-only so I can't reload the files or change the directory.  I tried the RS232 port but I can't get it to respond to commands even though I can see the processor boot.

[Sam_Sharp]

In the worst case scenario, you should be able to reformat the cRIO from MAX?

[nyc_(is_out_of_here)]

---

@lockmas wrote:

I loaded files on the cRIO but used upper case letters for the startup directory.  Now I cannot access the RIO since it didn't boot. The proxy server comes up read-only so I can't reload the files or change the directory.  I tried the RS232 port but I can't get it to respond to commands even though I can see the processor boot.

---

There is NO need to put your entire question into the subject line of your post.

cRIO will not boot is a suitable subject line