I am pretty new at Labview programming and this might just be a understanding problem from my side. But here goes anayway, this is What I want to do.
1) Have labview setup my NI9201 to trigger when it measures a 10V signal (I can do this)
2) Once the daq system is running have labview go off and activate the 10 volt source (usb comands that I can allready also do)
3) now that signal is active the Daq system should trigger and record the 60 seconds worth of data from three channels
The individual steps are realtively easy to setup I just don't understand how to get labview to one thing after another. This means currently my program runs the daq part and then turns on the signal (not very useful). Also I can't figure out how to turn the daq off once it has collected 60seconds of data.