LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

Problem about chart show and graph show

Solved!
Go to solution

Hi all,

I am running a simple program on RT target PXI 1071 with a DAQ 6356. The program runs well but the results showing on the chart and graph are not what I want.

The timeout of the DAQ is set as 0.1s, so the result on the graph will update every 0.1s. However, I want to get the accumulated result from the start to the end. What change I need to make to get what I want?

And I do no understand the result from the waveform chart. Is there anything wrong with it in the program?

Thanks

best regards

 

 

 

1.png

 

 

 

0 Kudos
Message 1 of 2
(2,034 Views)
Solution
Accepted by topic author iyearn

I don't know how you've set-up your DAQ Assitant task but presumably you're acquiring chunks of data.

I believe at each iteration of the loop the graph is displaying only the most recently aquired chunk of data and the chart is piling them up and keeps only the last 1024 points (not chunks, but points) because by default the history length of the chart is 1024 points, maybe what you need is to set a larger history length (right clic on the chart).

 

Hope this helps, and if not put a screen shot of the front panel and explain what the chart & graph are displaying (instead of what you want) because right now I'm only guessing.


We have two ears and one mouth so that we can listen twice as much as we speak.

Epictetus

Antoine Chalons

0 Kudos
Message 2 of 2
(2,015 Views)