10-24-2007 02:59 PM
10-25-2007 11:28 PM
01-22-2008 03:05 AM
Hi,
I exactly have the same problem today.
Did you find any solution ?
regards
01-22-2008 01:22 PM
Unfortunately, I do not have a straight/convinient solution for that. A couple of thing you can try:
1 Get a CEI-830 card with the PXI form factor. They do have the customized form factor for CEI-830.
2 Try to write your own LabVIEW RT driver for CEI-620. I've been trying to do that...no luck yet.
Hopefully that helps you at least a little.
Martin
01-22-2008 06:22 PM
01-23-2008 08:26 AM
Hi Eric,
Thanks for your information. I believe I tried this before, but dropped in the midway. The reason is that all these are dealing with interrupt-based devices, but unfortunately CEI-620 only uses polling mode. May be I am wrong, but I'll look through the artical again, and see if I get any luck this time.
Please advise if you have some further information.
Martin
01-24-2008 08:11 AM
Thank you for your help Eric.
Your link is interresting and I was happy to find this one in this page.
But I could not install my CEI-620 board with VISA, even if I have created the .inf.
MAX still cannot see the board.
T.
01-24-2008 10:59 AM
08-13-2008 04:48 PM
08-14-2008 04:35 PM
Hi Fayet,
The CEI 830 card is supported for LabVIEW RT with a on a PMC-to-CompactPCI/PXI Adapter.
Please check this link.
Please also check with the manufacturer of CEI to see if they have any specific drivers for this.
Thanks!