LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

LabVIEW Measure Period of a waveform

Hello. I am doing measurements, specifically I measure current of a motor and record data in a csv file. I have a square wave signal on a dedicated pin where I can measure square wave that will give information of the speed. I am trying to measure directly period of the square wave in a LabVIEW so I don't need to calculate it in a software. But the problem is that I can only measure 1 period , but not continuously over the whole signal. I was trying to use NI Scope Multi Fetch Measurements I choose there Period but I can only record 1 period. Can you please help me . Thank you. I added part of the VI that is responsible for data acquisition

0 Kudos
Message 1 of 3
(133 Views)

Well you don't have a While Loop around your program. So it is only going to run once and exit.

 

 

========================
=== Engineer Ambiguously ===
========================
0 Kudos
Message 2 of 3
(96 Views)

But when I extract the waveform components I don't need a loop. So, I put it in a loop, how I should wire it?

 

0 Kudos
Message 3 of 3
(57 Views)