Showing results for 
Search instead for 
Did you mean: 

Interfacing Omega PX309-500G5V with NI USB-6001

Currently having quite a bit of confusion working with an Omega pressure sensor. The Spec sheet for it is attached. I believe my wiring is set up correctly, but I keep getting output voltages of 4-10mV at atmospheric pressure. These values are much lower than expected. Is there an equation I should be using to convert this voltage to pressure? Any tips would appreciated, very new to working with labview and interfacing with sensors so go easy on me. Thanks!

0 Kudos
Message 1 of 2

No need for a response I have realized my mistake. Sensor reads PSIA not PSIG

0 Kudos
Message 2 of 2