From 04:00 PM CDT – 08:00 PM CDT (09:00 PM UTC – 01:00 AM UTC) Tuesday, April 16, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

Hold off DMA transfer

Hi,

 

 I have a DMA connected to a SPI driver. The device on the other end of the SPI bus (the slave) gives a sync signal telling when data it is outputiing is valid (As it outputs trash before before hand). I was wondering how can I suspend the DMA transfer based on the sync signal?!. Any data already in the DMA should still be sent to the host even if its input is suspended at a give time.

 

Hopefully this question is clear ;0

 

Thanks 😉

0 Kudos
Message 1 of 1
(1,918 Views)