Our online shopping is experiencing intermittent service disruptions.
Support teams are actively working on the resolution.
Our online shopping is experiencing intermittent service disruptions.
Support teams are actively working on the resolution.
03-31-2022 04:03 AM
Hi all,
I have LabVIEW 2021 installed.
I'm very new to LabVIEW/computer programming and have little to no knowledge, apologies for the basics in this message.
I've recently completed Core2 LabVIEW training so have some experience with using the software.
I have an Exfo LTB-8 with the following modules inserted into the chassis.
OTDR - 720C
Light Source - 2150
Power Meter - 1750 x 4
Attached is a PDF from Exfo explaining how to connect to this unit via LabVIEW/Ethernet, however, I cannot seem to add this in the block diagram or front panel.
I think the part I'm struggling with is adding this to NI MAX due to not knowing the port name of the device, also page 13/14 on the PDF is confusing, again the lack of knowledge with this.
Any help/guidance would be extremely appreciated.
Thanks in advance,
Bilchu
03-31-2022 06:09 AM
04-18-2022 04:57 PM
Try this out. See if your specific instrument has a LabVIEW driver ready to go.
03-15-2024 09:19 AM
Hi,
The document talks about a sample LV program. Do you by any chance have it? Can you please forward it?
thanks,