From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Digital I/O

cancel
Showing results for 
Search instead for 
Did you mean: 

Manual simulation for 6514 digital inputs

Hi,

 

I am developing an application using 6514. The 6514 is for monitoring some sensor values of the machines.

The card is not available yet so I need to simulate somehow the different sensor status scenarios.

Is there any test/debug panel available to manually simulate the input values of the 6514 while my application is running.

The device is already simulated in NI-MAX with “Simulated NI-DAQmx Device …” but no manual simulation possibility was found.

 

Regards,

0 Kudos
Message 1 of 2
(1,663 Views)

Unfortunately not.  Go give this idea a Kudo: Interactive DaqMx simulation interface ... (Popup panels for simulated hardware) 

 

As far as testing your code, depending on your architecture you could create a simulation class to test your logic.


GCentral
There are only two ways to tell somebody thanks: Kudos and Marked Solutions
Unofficial Forum Rules and Guidelines
"Not that we are sufficient in ourselves to claim anything as coming from us, but our sufficiency is from God" - 2 Corinthians 3:5
0 Kudos
Message 2 of 2
(1,656 Views)