C programming command

[lizardtrader]

will like to know how to configure the following command for NI_DAQMX. 

DIG_Line_Config DIG_Out_Line AO_Configure AI_Configure are NI_DAQ command

[Sean_F]

Hi there.

It sounds like you're upgrading from traditional DAQ to DAQmx. The easiest way to make the transition would be to check out the examples that come with DAQmx. If you've installed text-based support, you'll find examples by going to Start» All Programs » National Instruments » NI-DAQ» Text-Based Code Support » ANSI C Examples . Also, here is a link to a dev zone article that should make the process a little easier.

Hope this helps!

-Sean

[lizardtrader]

thanks for the reply

to make my work more simple ,do u have the functions for daqmx related to the traditional command used below

example will be AI_Configure(daq) == DAQmxCreateAIVoltageChan (daqmx)

thanks U

Init_DA_Brds

NIDAQErrorHandler

AO_VScale

AO_Write

DIG_Out_Line

DAQ_Clear

AO_Configure
DIG_Line_Config

AI_Configure

AI_Read

AI_VRead

AO_VWrite

[Sean_F]

Hello again,

The link I sent you ( http://zone.ni.com/devzone/cda/tut/p/id/5957 ) describes the parallels between traditional daq and daqmx. Also, notice that this is only part 1. At the bottom of the article are links to parts 2,3, and 4 of the tutorial. I'll link them here for you: part2, part3, part4 .  Also, like I mentioned before, I would strongly suggest running some of the daqmx examples. You can get to them by going to Start » All Program » National Instruments » NI-DAQ » Text-Based Code Support » ANSI C Examples.

Hope this helps!

Sean