Automotive and Embedded Networks

cancel
Showing results for 
Search instead for 
Did you mean: 

Error Frame logging using NI-XNET hardware

Hi all, I am using NI-XNET hardware (PXI-8513 board) to send diagnostic messages to electronic control unit devices.

I am logging transmitted and received CAN messages. Now I would also to log error frames messages.

How can I perform this?

 

Regards,

 

Claudio

0 Kudos
Message 1 of 2
(5,788 Views)

just set the interface property

 

Interface:Bus Error Frames to Input Stream? = TRUE

 

The Bus Error Frames to Input Stream? property configures the hardware to place a CAN or
LIN bus error frame into the Stream Input queue after it is generated. A bus error frame is
generated when the hardware detects a bus error. For more information about the bus error
frame, refer to Special Frames in the NI-XNET Hardware and Software Manual

 

btw this feature was introduced in NI-XNET 1.7

Message 2 of 2
(5,786 Views)