I want to make sure it's ok to mix the two. I have five CB-3's and one CB-1. Are there electrical differences? Message Edited by Daddy-O on 06-23-2008 02:13 PM
... View more
Utilizing a CB-3 connector block with a cFP-TC-120 module to read millivolt sensors. Sensors are pressure sensor with an excitation of 10V. Millivolt signal ranges from 8mv to - 70mv. Have all 8 diff...
... View more
Hi, Is it OK to connect a cFP-CB-3 through a 30 or 40 foot cable to a backplane (with a TC-120 module & cFP-1808 backplane)? It seems this would be neater than running separate TC wires. Th...
... View more
I am connecting a cFP 1808 directly to a computer using an ethernet crossover cable. The computer is not connected to a LAN. I configured a static IP address for the PC and the 1808 controller (using...
... View more
I am connecting 2-wire and 3 wire 4-20ma Sensotec sensors in the cFP-CB-1 with cFP-AI-100 and cFP-AI-110 modules. There are Voltage and Com connections I am assuming could be used to supply power to ...
... View more
I am using a cFP-CB-1 in conjunction with cFP-Ai-112 and cFP-2200. The manual for cFP-CB-1 says that it has a built- in CJC and can be used to take thermocouple measurements. I am pretty new to usi...
... View more
I want to buy some products. Below are some products.Is there anyone help me how can I get it from NI.
1. cFP-1808, 8 slot Ethernet/Serial Interface for Compact FieldPoint.
2.cFP-QUAD-510, Qu...
... View more
I am working on an experiment involved with monitoring the level of water in a tank as well as its temperature.
I need a counter module to measure Hz from an OMEGA flow meter, an input/outpu...
... View more
Hello, My question is what would be the best interface to communicate with LabView? Is what I have enough for my instruments to communicate with LabView? I have the following equipment from NI: ...
... View more
dear friends! Please, how can I read the attached file (test.txt) with LabVIEW 8.6. In the same VI, can I convert it into a real txt file with the results presented in rows and columns? Please, a...
... View more
