I want to make sure it's ok to mix the two. I have five CB-3's and one CB-1. Are there electrical differences? Message Edited by Daddy-O on 06-23-2008 02:13 PM
... View more
Hello All,
I am looking at upgrading an existing compact field point unit to a cDAQ unit and I am figuring out a way to test the new system without having to unwire and re-wire all of the old compa...
... View more
I am using a cFP-CB-1 in conjunction with cFP-Ai-112 and cFP-2200. The manual for cFP-CB-1 says that it has a built- in CJC and can be used to take thermocouple measurements. I am pretty new to usi...
... View more
hi
I use the module cFP-DIO-550 with a cFP-CB and I do not know how to connect my system with this module, for exemeple I want to connect the gate of a triac with the output 0 is that I need other ...
... View more
Hi guys, I'm currently working on a project that requires the measurement of air flow rate and we're using a Dwyer Series 641B Air Velocity Transmitter to do so. I've set it to the 4 mA setting,...
... View more
Hi
I just instaled 4-20 mA pressure transmitter with cFP-CB-1 field point with 5V supply voltage but could get any thing on measurement system. Can some body guide what is the basic instalation...
... View more
I need to wire a two-wire loop powered 4 to 20 mA current output sensor using cFP-AI-111 and cFP-CB-1. This is the first time I've encountered a sensor like this. Looking at the schematic for the s...
... View more
I am connecting 2-wire and 3 wire 4-20ma Sensotec sensors in the cFP-CB-1 with cFP-AI-100 and cFP-AI-110 modules. There are Voltage and Com connections I am assuming could be used to supply power to ...
... View more
I'm using a cFP-DO-401 to control 24V valve solenoids. On
page 4 of the cFP-DO-401 manual it says to fuse the outputs with 1.5A
fast acting fuses, which makes sense. But, rather than put an in-li...
... View more
