NI Community

Hi,   I am new to LabVIEW and currently I want to use a waveform generator (5412) and a terminal block (TB-2708) on PXI to generate a signal and receive signal data, respectively.  I looked some ... ... View more

Configuration tree in Measurement and Automation (MAX) does not show  newly installed NI-DAQmx (PCIe-8360) device ... View more

Hi all,   I want to connect a 7852R FPGA card with an SCB68 box.    The recommended cables for the MIO or DIO connectors are the SHC68-68-RMIO, -RDIO cables. For both connectors there is also t... ... View more

Hi all,   i m trying to create a vi for getting voltage data  from a micro edm machine.I implemented that both with oscilloscop and PCI 6115  and the results were completely different.My question i... ... View more

I am currently working on my thesis trying to create a program to send 4 analog voltage signals to 4 different transducers simultaneously (numbered 1 to 4 in diagram below) using NI PXI-6115 I/O modu... ... View more

Hi All, I have posted about this problem previously but i could not get a sufficent answer.My data acqusition card is PXI 6115 and I have TB-2708 DAQ module.I have been trying to get data from a mic... ... View more

Hello, I'd like to measure an incremental decoder with the PXI-6120. About the same question was already asked before:   http://forums.ni.com/t5/Multifunction-DAQ/6120-encoder/m-p/776882/highli... ... View more

Hi All,   I am wirting to program that should have a synced an analog input and a digital output on PXI-6143 using Start Trigger. The trigger signal is set to use software trigger generated by an... ... View more