Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
75 results
Sorted by:
09-03-2009
11:16 AM
This example demonstrates how the PXI-4132 Precision SMU can be used to source voltage points in a sequence and handshake with a DMM so that both instruments can measure the output.
How the handsh...
... View more
03-15-2013
08:57 AM
4
Hello!I started to use the power supply NO PAN 4132.Tell me please, what channels should be connected to receive the voltage 50 V Current consumption is 70mA.I connect to the channel "Output High Ter...
... View more
02-24-2012
03:58 AM
6
Hi all,
I'd like to know how to wire the PXI-4132. You can check its specification following links below.
http://sine.ni.com/nips/cds/view/p/lang/fr/nid/207349
http://www.ni.com/pdf/man...
... View more
Show results in replies (6)
-
Hi, You can call VIs from TestStand or use the DAQmx driver so I think it should be poss...
-
...easurement) or a current (series measurement) does the pxi-4132 switch from one to another by itself ? &n...
-
Thank you so much for the support. BR Vincent
-
...emote Sense Connections for Cascaded Power Supplies Architecture Details of the NI PXI-4132...
-
Hi, It seems that output guards are recommanded for very small measurements. So wiring t...
-
Hi Jeremy, That is very helpfull. But like answers generate questions... Can ...
01-14-2013
11:25 AM
16
I have observed PXI 4132 sometimes is load dependent. We were testing one particular device which is a bi-directional part and when we forced a current across the device in the negative direction th...
... View more
08-09-2019
07:15 AM
3
I have NI PXI-4132 installed in NI PXIE 1073 chassis. I am not good at programming. I am desperately looking automated software for measurement. I found NI Power Device Soft panel can do sweep measur...
... View more
05-22-2012
08:56 AM
2
Hello,
I am working with a NI PXI 4132.
I have an issue when i set 0A to source. The programm reurns an invalide value. But it is weird bcause i can set 0V. It works fine.
In 50mA range 40V...
... View more
05-20-2013
09:52 PM
3
Hello,
I'm trying to use my old PXI-1031 as chassis for my PXI- 4132 SMU but i have problem on +12v supply from chassis.
Is PXI-4132 compatible with PXI- 1031? Additional to that I'm using PX...
... View more
04-22-2012
11:45 PM
1
Hi,
I am using a SMU PXI 4132 to measure current and voltage. The DUT I am using is a diode. I am doing voltage measurement followed by leakage current measurement. Voltage measurement is done ...
... View more
04-30-2014
09:40 AM
1
I have an NI PXIe-1073 chassis with an NI PXI-4132 card installed.
I had the system turned off over the weekend & started it up to do some linearity measurements on an ADC yesterday. As usual,...
... View more
04-05-2018
03:06 PM
1
Hi Colleagues.
Lately I'm having a problem of measuring low R devices with high R leads using PXI-4132 SMU.
Here is my situation: I have on-chip devices that have on-chip resistors as well. I nee...
... View more
