Wireless Sensor Networks

cancel
Showing results for 
Search instead for 
Did you mean: 

How to make the connections on the outputs of the letter wsn 3202?

Solved!
Go to solution

Goog  morning Engineers,

 

How to make the connections on the outputs of the letter wsn 3202?

Hugo Santos
Student at ISEC - Master Mechanical Equipment and Systems
0 Kudos
Message 1 of 12
(6,566 Views)

Connections to what?  What are you trying to control/measure?

Chris
Certified LabVIEW Architect
Certified TestStand Architect
0 Kudos
Message 2 of 12
(6,560 Views)

The situation is as follows, I intend to obtain a value of output voltage of the deviceWSN 3202, through a condition imposed in labview (example attached), I intend tooperate a relay. But until now still can not get any kind of value.
Greetings.

Hugo Santos
Student at ISEC - Master Mechanical Equipment and Systems
0 Kudos
Message 3 of 12
(6,554 Views)

Attached sending

Hugo Santos
Student at ISEC - Master Mechanical Equipment and Systems
0 Kudos
Message 4 of 12
(6,553 Views)

Okay, that VI looks fine.

 

Are you not seeing the output values?

Do you read good input values?

Chris
Certified LabVIEW Architect
Certified TestStand Architect
0 Kudos
Message 5 of 12
(6,550 Views)

Yes I see the input values​​.
But the doors do not get any output value. 

(Attached will the calls made.)

Hugo Santos
Student at ISEC - Master Mechanical Equipment and Systems
0 Kudos
Message 6 of 12
(6,547 Views)

You need to supply DIO Power (pin 17).

Chris
Certified LabVIEW Architect
Certified TestStand Architect
0 Kudos
Message 7 of 12
(6,544 Views)

I've done that. I called the Power DIO - DIO 0 and not obtained anything. Will have to give the value in the program?

Hugo Santos
Student at ISEC - Master Mechanical Equipment and Systems
0 Kudos
Message 8 of 12
(6,542 Views)
Solution
Accepted by topic author hugosantos

Sorry, I'm very confused by your response.

 

You should not need to set anything about the power programmatically, just wire up a power supply to DIO Power and the DIO Ground.  Then your DIO lines should be able to output values.

 

Also, I do think you may need to setup the line as output.  This would be done from the project.  I don't remember which element it is, but it should be in some Properties menu (probably for the specific DIO line).

Chris
Certified LabVIEW Architect
Certified TestStand Architect
0 Kudos
Message 9 of 12
(6,540 Views)

Thanks for your reply, helped a lot. I'll try again, and then say what was the result.
Regards.

Hugo Santos
Student at ISEC - Master Mechanical Equipment and Systems
0 Kudos
Message 10 of 12
(6,536 Views)