Browse by label or search in the Vision Idea Exchange to see if your idea has previously been submitted. If your idea exists, be sure to vote for the idea by giving it kudos to indicate your approval!
If your idea has not been submitted click New Idea to submit a product idea. Be sure to submit a separate post for each idea. Note: Please post technical vision support questions to the Machine Vision forum, not the Vision Idea Exchange.
Watch as the community gives your idea kudos and adds their input.
As Vision R&D considers the idea, they will change the idea status. Note: Vision R&D is committed to reviewing every idea posted in the Vision Idea Exchange. However, the implementation of any Vision Idea Exchange submission cannot be guaranteed.
Give kudos to other ideas that you would like to see implemented!
Problem Description : I am unable to enter more than two places past the decimal when entering in tolerance into the pass inspection if..... is there an update that can fix this issue? I believe this has never been addressed in any of the new versions of VB. I can hold micron tolerances but cant do any pass fail because when i put the numbers in they round up or down. they may be going in but i cant see them and therefor cant refer back to what was put in because they do not show past the 2nd decimal place.