Just open the VI in LabVIEW 2020. Are you having an issue opening it?
I can open the file just fine. When I click Run an Error -201003 occurs. It reads "Error -201003 occurred at DAQmx Create Channel (AO-Voltage-Basic).vi:187005"
Device cannot be accessed. Possible causes:
Device is no longer present in the system.
Device is not powered.
Device is powered, but was temporarily without power.
Device and/or chassis driver support may have been removed.
Device is damaged.
Ensure the device is properly connected and turned on. Ensure the device and/or chassis is supported in the current version of the driver. Check the device's status in NI MAX. Turn the computer off and on again. If you suspect that the device is damaged, contact National Instruments at ni.com/support.
Device Specified: cDAQ1Mod1
Task Name: _unnamedTask<0>
The device I'm using is no longer supported by the current NI DAQmx. I had to download some old drivers, but I don't know if the old drivers are compatible with LabView 2020. Are they?
According to that, you can use up to DAQmx 17.5.
Then read NI-DAQmx and LabVIEW Compatibility
According to that, the newest version of LabVIEW that supports DAQmx 17.5 is LabVIEW 2017.