07-06-2021 03:28 AM
I m using USRP-2974 remotely Through Host. Computer. I Have Installed Labview Communication Design Suit 5.0 And USRP Instrument Driver 20.5 On Host Computer.
RJ45 Ports Communication ok and USRP Detected in Labview Comminication Design SUIT.
SFP Port 0 Communication not Ok USRP not Detected in Labview Comminication Design SUIT.
SFP Port 1 Communication not Ok USRP not Detected in Labview Comminication Design SUIT.
Kindly Guide about Connectivity Issue Through SFP Ports.
07-16-2021 09:37 AM
Hi,
This USRP-2974 host supports multiple, high-speed, low-latency interface options to the FPGA. To setup the device, follow these basic instructions:
For more details on network setup, including PCIe connectivity, please see the section Interfaces and Connectivity of the NI USRP-2974 Hardware Resources page.
1G/10G ETH 0 | SFP+ port used for 10G ETH connectivity to other ethernet devices. Connects to the embedded Linux computer for communication with LabVIEW RT. | |
1G/10G ETH 1 | SFP+ port used for 1G/10G ETH connectivity to other ethernet devices. Connects to the FPGA. Not currently supported in LabVIEW Communications System Design Suite. |