Good morning,
I have an issue whereby I have used hardwires to connect one pole of two switches to each other. The other pole end of each switch is connected to a UUT pin (UUTP1 and UUTP2). The switches are different items of hardware. I would expect that if I connect UUTP1 to the hardwired pole, the route would be found, and it is. But if I connect UUTP2 to the same hardwired pole, NISE reports the channel 'does not satisfy new constraints'. I assume the reason is the card route specs are different. Is there a way to ignore the error and allow the connection across different hardware switches?
Thanks
Steve
