Signal Generators

cancel
Showing results for 
Search instead for 
Did you mean: 
Reply

Error launch RFSG Soft Panel

HI.

I have Labview 2016. I set up new drivers Jan.2019. And when I launched RFSG soft panel I have an error:Error.png

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

What I must do to launch panel? Thanks.

0 Kudos
Message 1 of 7
(379 Views)

Hi Valentin87,

This is usually a result of your firewall blocking the application.  Can you verify that LabVIEW and the RFSG Soft Front Panel are not blocked by your security software?

Luke B.
National Instruments
Applications Engineering
www.ni.com/support
0 Kudos
Message 2 of 7
(338 Views)

No, firewall is not block.

0 Kudos
Message 3 of 7
(333 Views)

Do you get this error when opening any of the other soft front panels or is just this one?

Luke B.
National Instruments
Applications Engineering
www.ni.com/support
0 Kudos
Message 4 of 7
(324 Views)

This error only in RFSG panel.

0 Kudos
Message 5 of 7
(320 Views)

If it's only affecting the NI RFSG soft front panel, trying to reinstall just NI-RFSG is a good next step.  Also, in LabVIEW check the Machine Access settings for the VI driver to see if it's allowing all IP addresses (http://zone.ni.com/reference/en-XX/help/371361P-01/lvhowto/settingtcpipaccessforvisrv/).

Luke B.
National Instruments
Applications Engineering
www.ni.com/support
0 Kudos
Message 6 of 7
(291 Views)

As a troubleshooting step, can you try launching the NI-RFSG Soft Front Panel as Administrator?

I.e., click Start, find the Soft Front Panel, right click and Run as Administrator.

0 Kudos
Message 7 of 7
(286 Views)