01-31-2019 04:14 PM
The shunt calibration DAQmx wizard provides the option to select one of the bridge completion resistors to shunt for the calibration. How should I select which one will be used for a shunt calibration of a full bridge III configuration? I'm using an NI-9237 bridge measurement module.
02-01-2019 07:56 AM
We also use the NI-9237 and as far as I know, the only settings which can be adjusted are
by right-klicking on the cRIO-Module in the Project tree.
Good luck
02-01-2019 12:38 PM
Hello Testr00,
Please follow the next guide to learn more about the Shunt Calibration setup for the NI-9237: Connecting Strain Gages to a DAQ Device. Figure 21 shows how you select the resistance to calibrate.
You can also find more information in these documents: Connecting Strain Gages and Shunt Resistors to the NI-9237 and Measuring Strain with Strain Gages.
I hope this information is useful for you!
All the best,