Signal Conditioning

cancel
Showing results for 
Search instead for 
Did you mean: 

Connecting Piezotron Coupler to NI 9232

Highlighted

Hello, is there possible way to connect Piezotron Coupler (cable socket should be an EMC-protected type) to screw terminal NI 9232.

I will post some photos for references. Thank you.


IMG-0991.jpgIMG-0987.jpgIMG-0988.jpgIMG-0989.jpg

0 Kudos
Message 1 of 2
(168 Views)
Highlighted

There are some ways to do it... 🙂

Depending what you want to measure... assuming you want the rms output, you need to provide an extra powersupply (22V-30V) 

But the question is, why you want to use the coupler?

The 9232 supports IEPE/Piezotron/CCLD/... sensors directly, if you want to measure the sensor output.

You can do the rms measurement in software. Just short adapter screw to BNC ... done 🙂

 

Greetings from Germany
Henrik

LV since v3.1

“ground” is a convenient fantasy

'˙˙˙˙uıɐƃɐ lɐıp puɐ °06 ǝuoɥd ɹnoʎ uɹnʇ ǝsɐǝld 'ʎɹɐuıƃɐɯı sı pǝlɐıp ǝʌɐɥ noʎ ɹǝqɯnu ǝɥʇ'


0 Kudos
Message 2 of 2
(127 Views)