08-01-2007 03:18 PM
I am trying to read four voltage signals and write them into a MS excel sheet. When I tried this I got only the last set of data. For an example when I run the vi for few minutes just 6 numbers of readings were there. How can I write the data during entire data acquisition period? Thank you in advance.
amaka
08-02-2007 04:05 PM
08-03-2007 09:32 AM
Hi Yi,
I have herewith attached a sample vi. This is the kind I want. Problem of this one is that in every cycle it asks a new file name. I wan to write the signal data continuously until the program stops. What modification should I do for that?
Thank you very much.
amaka
08-03-2007 03:32 PM - edited 08-03-2007 03:32 PM
Message Edited by Yi Y on 08-03-2007 03:33 PM
08-04-2007 11:25 AM
Hi Yi,
Thank you very much. Now I got it.
I have one more question for you. Is there any way for me to read the specific cell of the excel sheet after the data is written. For an example if I want to read A2 of the excel sheet how can I do that.
Thanks,
amaka
08-06-2007 03:55 PM
08-07-2007 02:42 PM
Hi Yi,
Thank you for the guidance. I tried to generate the activex but I am not sure how should I finally link this to my vi to input the information in the cell. The data type I want to read is numeric.
Thanks
Amaka
08-08-2007 02:40 PM