Real-Time Measurement and Control

Showing results for 
Search instead for 
Did you mean: 

real time acquisiton and processing of EEG signal in LABVIEW

I'am trying to acquire single channel EEG on LABVIEW based on Arduino board. How can i increase the amplifier's gain in order to get a good signal ?? 

0 Kudos
Message 1 of 4

Is this an external amplifier? Or an on-board amplifier that the Arduino has? What does your hardware setup look like?

0 Kudos
Message 2 of 4

Its an external amplifier hooked up with arduino board on A0 GND and 5V. 

0 Kudos
Message 3 of 4

This forum is usually only supports NI products themselves, so I don't know if you'll get a lot of help directly from here about how to work amplifiers.


But researching how amplifiers work would be a good start!


Here is a basic explanation on how gain works.


Operational Amplifier, Op Amp Gain & Equations: 

0 Kudos
Message 4 of 4