From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Hardware Boards Real-Time Measurement and Control Topic

Real-Time Measurement and Control

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

how to connect more than one spectrum analyzer into LabVIEW?

how to connect more than one spectrum analyzer into LabVIEW?

‎07-20-2017 11:23 AM

I'm new in here, i have 3 spectrum analyzer FSL 18 and I want to know how to connect those 3 spectrum into labview and give the result into a single graph in real time measurement. Do i need a multiplexer? Anyone can recommend me anything about those multiplexer? Thank you.

0 Kudos
Message 1 of 2
(2,342 Views)
Reply

Re: how to connect more than one spectrum analyzer into LabVIEW?

‎07-20-2017 12:27 PM

You're probably on the wrong forum. This is a real time forum. Most instruments allow daisy chain but some interfaces require you to setup each instrument on a different address. It depends on the interface.

 

If you have a third party instrument (not an NI spectrum analyzer), this is probably the best forum to ask questions: https://forums.ni.com/t5/Instrument-Control-GPIB-Serial/bd-p/140

Message 2 of 2
(2,332 Views)
Reply