Real-Time Measurement and Control

cancel
Showing results for 
Search instead for 
Did you mean: 
Reply

Target and Devices option not available

Solved!
Go to solution
Highlighted

I have newly installed the LabVIEW 2017 evaluation version. I wanted to use the LabVIEW for interfec with cRIO 9022. I was able to obtain the device in NI MAX (remote systems). But when I tried to add the device in the project, I could not do as the "target and Device" option in the right click of the project name icon was not available.

Could I get a solution to obtain the icon in the LabVIEW project.

Thank you.

 

0 Kudos
Message 1 of 4
(418 Views)

Did you install that cRIO drivers that are compatible with LabVIEW 2017?  Did you install the LabVIEW RealTime and LabVIEW FPGA toolkits?


There are only two ways to tell somebody thanks: Kudos and Marked Solutions
Unofficial Forum Rules and Guidelines
Message 2 of 4
(403 Views)
Solution
Accepted by topic author Pakku
05-16-2018 03:54 AM

I second crossrulz advice, and add that there is an order you need to install in:

1. LabVIEW

2. LabVIEW Toolkits / Modules (Real-Time, FPGA)

3. Drivers (CompactRIO)

 

If you installed CompactRIO first it could also lead to this behavior.

Andrew T.
"His job is to shed light, and not to master" - Robert Hunter
0 Kudos
Message 3 of 4
(375 Views)

Yeah sir I had installed. I found the solution.

Actually Real time tool box 2017 is compatible only for 32bit LabVIEW.

So, I had to install 32 bit 2017 LabVIEW along with Real time windows 17.0, FPGA toolbox and then the CRIO driver 2017.

 

Thank you

0 Kudos
Message 4 of 4
(352 Views)