I have been on SEA's website for this module and it shows the following information on the driver page:
Part Number: 60000006
SEA 9510 is a 3-Port EnDat 2.2/2.1 interface module.
April 2019: New driver version available!
Supports the new NI cRIO-904x and cRIO-905x targets
Supports LabVIEW 2017 or higher
I have installed the latest driver using VIPM as instructed, and I am using 2020 versions of LabVIEW and the cRIO realtime/FPGA support files. But I cannot get the modules to be detected. The modules do show up in MAX and I have selected the LabVIEW FPGA programming mode for the modules.
I would like to know if anyone else has experienced this issue and, better yet, was able to resolve the it.