From 12:00 AM CDT Sunday, October 17 - 11:30 AM CDT Sunday, October 17, ni.com will be undergoing system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Real-Time Measurement and Control

cancel
Showing results for 
Search instead for 
Did you mean: 

SEA 9510 EnDat 2.2 module won't install in cRIO 9045

Hey,

 

I have been trying to install the SEA 9510 EnDat 2.2 module (https://www.sea-gmbh.com/en/products/compactrio-products/interface-busses/sea-9510-endat/) into my cRIO 9045 but when trying to discover the modules in my LabVIEW project explorer window, and add them to the FPGA I get the error message as shown below. 

 

DeepSpace_0-1616354111068.png

 

I have been on SEA's website for this module and it shows the following information on the driver page:

Part Number: 60000006

SEA 9510 is a 3-Port EnDat 2.2/2.1 interface module.

April 2019: New driver version available!

  • Supports the new NI cRIO-904x and cRIO-905x targets
  • Supports LabVIEW 2017 or higher

I have installed the latest driver using VIPM as instructed, and I am using 2020 versions of LabVIEW and the cRIO realtime/FPGA support files. But I cannot get the modules to be detected. The modules do show up in MAX and I have selected the LabVIEW FPGA programming mode for the modules.

 

DeepSpace_1-1616354863640.png

 

 

I would like to know if anyone else has experienced this issue and, better yet, was able to resolve the it.

 

Thanks so much.

 

0 Kudos
Message 1 of 1
(211 Views)