Real-Time Measurement and Control

cancel
Showing results for 
Search instead for 
Did you mean: 

SCLK / SPI_CLK as DIO / GPIO on cRIO

Hello everyone,

we want to build a custom module and were wondering whether it is possible to use the SCLK/SPI_CLK pin (#11 on cRIO connector) on the cRIO connector as a DIO/GPIO.
Is this pin shared by all modules or per cRIO module?
If i interpret the documentation right, the SCLK pin is driven high when entering normal operation mode. Is it afterwards possible to drive this pin to a constant 0 or 1 from within labview?

Sincerely
Mark French

0 Kudos
Message 1 of 2
(129 Views)

I believe it is possible. However, as per the documentation it is not recommended. 

https://www.ni.com/pdf/manuals/375951b.pdf page 41.

0 Kudos
Message 2 of 2
(69 Views)