Real-Time Measurement and Control

cancel
Showing results for 
Search instead for 
Did you mean: 
Reply

Re: FPGA Read/Write not working in cRIO 9073

crio 9073

i am running scan interface mode with 9205 AI module, saving the data in TDMS format. while in open tdms, i gave the file path as c:\ip address\ filename. then it is saving in the internal memory of crio. when i build the exe with same file .tdms file is not saving in the internal memory of crio, it is saving in the c-drive of computer. so how to save the file in internal memory of c-rio with .exe 

0 Kudos
Message 1 of 3
(1,286 Views)

Well, C:\ does not even exist on the cRIO-9073.  I recommend you give this article a good read: Working with File Paths on Real-Time Targets


There are only two ways to tell somebody thanks: Kudos and Marked Solutions
Unofficial Forum Rules and Guidelines
0 Kudos
Message 2 of 3
(1,276 Views)

Untitled.png

 

i am a beginer i couldnt get much

is this process is ok

as i mentioned earlier this is working fine,bulding exe with the same it is saving in my computers drive. 

0 Kudos
Message 3 of 3
(1,226 Views)