07-27-2013 02:38 PM
I have an old CRIO manual stating that the scan rate is 1KHz. Can the newer hardware (9025 and 9113) go faster than 1KHz?
Solved! Go to Solution.
07-30-2013 04:17 PM
Hello,
Regardless of the hardware it is recommended that when using Scan Mode on a cRIO to not exceed a rate of 1 kHZ. You can find more information in the CompactRIO Developer's Guide and going through this article about using Scan Mode with a cRIO.
07-30-2013 07:12 PM
But say a pilgrim did want to go faster, how would one do that?
07-31-2013 04:30 PM
Page 17 in the CompactRIO's Developer Guide is going to give you the best explanation. Anything over 1 kHz is going to have a dramatic impact on your CPU Usage. It is recommended anytime you would like to have rates faster than 500 Hz to run the application using LabVIEW FPGA programming.