From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Hardware Boards Real-Time Measurement and Control Topic

Real-Time Measurement and Control

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Incorporating 6030E into existing embedded application running Nucleus RTOS.

Incorporating 6030E into existing embedded application running Nucleus RTOS.

‎07-30-2002 03:26 PM

Is it possible to incorporate a 6030E card into my existing embedded application? I am running Nucleus RTOS and would like to offload processing to an intelligent Acq card. Can I communicate to the card?
0 Kudos
Message 1 of 2
(2,903 Views)
Reply

Re: Incorporating 6030E into existing embedded application running Nucleus RTOS.

‎08-01-2002 08:34 AM

While use of a PXI-6030E board is easy to configure using LabVIEW RT and the RTOS it uses, we do not offer drivers for our boards for third-party RT operating systems.

If you were to attempt to use this board in the Nucleus RTOS, you would need to first write a driver for it. You might start at http://stm.lbl.gov/comedi for 3rd party limited-functionality open-source linux drivers for our boards, which might be a good starting point. Please note that National Instruments offers no support for anything presented on the above web site, or for writing drivers for our boards in general.
0 Kudos
Message 2 of 2
(2,903 Views)
Reply