rol an external device. I have faced a problem that is how to send a "1" or "0" signal which lasts a time period of ns to specific lines. Because in Labview, all functions provided were milliseconds. I need ns. Please give me some help about this. Thanks!I'am afraid this is not possible without
extra equipment. Even a Real-Time system
does not go below few microseconds, while
a normal one uses miliseconds, that's why
the functions you found in LV are limited.
Use some fast speed programable timer/counters,
you set them before in LV and they will do
the work alone.
If you are satisfied with pulses of 2*12.5 ns,
PCI 6002 is the device for you (8 fast
bi-directional 80MHz counter/timers plus a lot
of normal, non-real time ports). I'am using it
since 2 years and performs fine.
Success