Real-Time Measurement and Control

cancel
Showing results for 
Search instead for 
Did you mean: 
Reply

How can I get the base address of the PCI-6025E board when programming in the registr-level?

Any suggestions or examples?
0 Kudos
Message 1 of 3
(2,652 Views)
Have you visited the DAQ Register Level Programming Resource page? You can find it at:

http://www.ni.com/support/daq/program/reg_prog.htm

This page will provide you with the resources that you need to register program a PCI E-Series board.

Regards,
Erin
0 Kudos
Message 2 of 3
(2,652 Views)
This is a PNP type card. So the BIOS will asssign a BaseAddress in the reserved Address range during the startup. you can find it on the device management area (BAR1).
0 Kudos
Message 3 of 3
(2,652 Views)