From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Hardware Boards Real-Time Measurement and Control Topic

Real-Time Measurement and Control

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

How can I get the base address of the PCI-6025E board when programming in the registr-level?

How can I get the base address of the PCI-6025E board when programming in the registr-level?

‎04-26-2001 09:33 PM

Any suggestions or examples?
0 Kudos
Message 1 of 3
(4,565 Views)
Reply

Re: How can I get the base address of the PCI-6025E board when programming in the registr-level?

‎04-27-2001 11:19 AM

Have you visited the DAQ Register Level Programming Resource page? You can find it at:

http://www.ni.com/support/daq/program/reg_prog.htm

This page will provide you with the resources that you need to register program a PCI E-Series board.

Regards,
Erin
0 Kudos
Message 2 of 3
(4,565 Views)
Reply

Re: How can I get the base address of the PCI-6025E board when programming in the registr-level?

‎05-18-2001 01:28 AM

This is a PNP type card. So the BIOS will asssign a BaseAddress in the reserved Address range during the startup. you can find it on the device management area (BAR1).
0 Kudos
Message 3 of 3
(4,565 Views)
Reply