Real-Time Measurement and Control

cancel
Showing results for 
Search instead for 
Did you mean: 

Flex RIO PXIe-7972R, Target to Host Continuous Transfer Speed,Maximum?

Highlighted

What is a reasonable fastest continuous DMA Target  to Host data transfer rate I can run?

0 Kudos
Message 1 of 3
(170 Views)
Highlighted

Depends on chassis, controller, and operating system configuration.

 

With a 7976 I've seen 900 MB/sec but this was limited by the disk.  The 7972 is similar.

 

The shipping example "High Throughput Streaming.lvproj" is able to run tests up to 2 GB/sec.

 

Do you have your hardware?  You can run this example.


Certified LabVIEW Architect, Certified Professional Instructor, LabVIEW FPGA expert
ALE Consultants
LabVIEW Programming (make LV more popular, read this)

LabVIEW FPGA for High Throughput Applications | VI Week 2020
0 Kudos
Message 2 of 3
(149 Views)
Highlighted

Thanks for the response....I'll take a look at "High Throughput Streaming.lvproj" once I have my hardware setup.

 

At this point of my design I am trying to figure out what is a reasonable data rate

Hardware this will run on is 

  • PXIe-1095, 18-Slot 3U PXI Express Chassis
  • PXIe-8880, Xeon 8-core 2.3 GHz controller, Red Hat
  •  6 PXIe-7972R, FlexRIO FPGA Module 
  • PXIe-8240, 40 Gb Ethernet Interface Module

I need to stream from one of the FlexRIOs back to the controller (which then sends it to the Ethernet Module)

 

If I don't compress I need to pass 32bit words at 20MHz......while other bus operations are happening on the other 5 FlexRIO

0 Kudos
Message 3 of 3
(129 Views)