Hello,
I have DANI robot starter kits 2.0 with sbRIO9632 and I'm trying to communicate with them.
I have nano router on each robot configured in client mode and give each robot a specific IP. I can see in the command that the IPs are what I configured. (attached pic).
However, when I run NI max and/ or Robotics hardware wizard, there are suddenly different IP addresses in those softwares and even the IPs in the command were changed - now there are two different IP addresses for the same robot (attached pics).
In this case I can't communicate with the robots... any help please?
Thank you in advance
Orit