Real-Time Measurement and Control

cancel
Showing results for 
Search instead for 
Did you mean: 

Configuring Troubles: cRIO-9014

Hello,

 

I have the cRIO system with a cRIO-9024 controller with the cRIO-9118 chassis. That is full configured and working like a charm.

 

Now I purchased a used controller cRIO-9014 and I would like to get it working with the same chassis - as it is compatible.

 

I connect it, reseted the IP configurations on the controller itself with the DIP switch.  I can scan and find the controller on NI MAX. I change the IP settings to DHCP and local link (as it is directly connected to my computer).  I change the name and comments that were left on the controller, save and hit the reboot. 

 

I look back into the settings and see no changes: IP settings, name and comments are all left untouched.  I double getting firewall and network settings (made sure I would obtain an IP address autonomatically). 

 

At this point I have an unconfigured controller (with IP address 0.0.0.0) and I cant get it configured. 

 

Any suggestions?

 

Daniel

0 Kudos
Message 1 of 2
(5,143 Views)

Hi Daniel,

 

Have you tried the steps in the following resource?

Paolo F.
National Instruments
Applications Engineer
0 Kudos
Message 2 of 2
(5,118 Views)