From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Hardware Boards Real-Time Measurement and Control Topic

Real-Time Measurement and Control

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Adding FPGA I/O on sbRIO9607

Re: Adding FPGA I/O on sbRIO9607

‎09-15-2018 02:28 AM

Thanks, dude! I got it. I'll make a doc

@nanocyte wrote:

You can use the IO but not with the convenient RMC project interface. You have to use the socketed clip interface and explicitly allow each IO.

 

The other solution (the one I implemented) is to write your own UART driver instead of using the CLIP. There's an example over here: https://forums.ni.com/t5/LabVIEW-Robotics-Documents/RS-232-Interface-Reference-Example-for-LabVIEW-F...


on it so in future there won't be any problem for the beginners. 🙂

0 Kudos
Message 11 of 11
(348 Views)
Reply