12-19-2011 05:38 PM
I am trying to use the CAN Basic example with a 9853 C-series module. I am getting the 65538 error on my CAN Input node. I'm not getting any errors on my output node. Can anyone give me any advice on this? I am sending messages from CAN1 to CAN0.
Thanks
12-20-2011 11:15 AM
Hello,
I have located the following KnowledgeBase that covers this particular error with the NI 9853: http://digital.ni.com/public.nsf/allkb/9426665895FC9E88862577C300801DB1?OpenDocument . Please let me know if verifying the proper termination helps.
Regards,
12-20-2011 12:40 PM
I had the baud rate set to the default of 500 kb/s. I switched it to 250 on each port and everything worked. Any idea why this would have been causing the problem?
12-20-2011 12:54 PM
It's highly probably that the termination on your cable was not compatible with the speed you were trying to transmit. Proper cable termination is covered here: http://digital.ni.com/public.nsf/allkb/B5D65DF99543205486256FA500670B09?OpenDocument and the symptoms of improper termination is covered here: http://digital.ni.com/public.nsf/allkb/E64E8655D2B41DBA86256A530055E6BA?OpenDocument