Real-Time Measurement and Control

cancel
Showing results for 
Search instead for 
Did you mean: 

65538 error code with CAN Basic example VI.

Highlighted

I am trying to use the CAN Basic example with a 9853 C-series module.  I am getting the 65538 error on my CAN Input node.  I'm not getting any errors on my output node.  Can anyone give me any advice on this?  I am sending messages from CAN1 to CAN0.

 

Thanks

0 Kudos
Message 1 of 4
(3,557 Views)
Highlighted

Hello,

 

I have located the following KnowledgeBase that covers this particular error with the NI 9853: http://digital.ni.com/public.nsf/allkb/9426665895FC9E88862577C300801DB1?OpenDocument . Please let me know if verifying the proper termination helps.

 

Regards,

Applications Engineer
National Instruments
Message 2 of 4
(3,552 Views)
Highlighted

I had the baud rate set to the default of 500 kb/s.  I switched it to 250 on each port and everything worked.  Any idea why this would have been causing the problem?

0 Kudos
Message 3 of 4
(3,550 Views)
Highlighted

It's highly probably that the termination on your cable was not compatible with the speed you were trying to transmit. Proper cable termination is covered here: http://digital.ni.com/public.nsf/allkb/B5D65DF99543205486256FA500670B09?OpenDocument  and the symptoms of improper termination is covered here: http://digital.ni.com/public.nsf/allkb/E64E8655D2B41DBA86256A530055E6BA?OpenDocument

Applications Engineer
National Instruments
0 Kudos
Message 4 of 4
(3,548 Views)