Q&A ๊ฒŒ์‹œํŒ

cancel
Showing results forย 
Search instead forย 
Did you mean:ย 

RT scan engine mode goes into configuration mode when error 66464 happens.

Hello, 

 

I'm using RMC-8354 and sometimes error 66464 happens and scan engine mode goes into configuration mode, however when I reset RT, it turns active mode again. I'm using several RMC-8354 servers but only one RT shows this error. I suspect this is uniquely from only one RT. I already googled and what is the meaning of error 66464. What I do know is how to fix it. not just information. I contacted some channels but answer was not okay to me. Please give some ideas of this problem. Thanks in advance!!

Best Regards,
-----------------------------------------------------------------------------------------------------------

There are only two ways to tell somebody thanks: Kudos and Marked Solutions
0 Kudos
Message 1 of 4
(265 Views)

Hi  gooohestpoo,

 

Have you tried comparing the software installed on a normal system with the software on the problem system?

As you know, error 66464 can happen when the iteration period of NI scan engine is changed.

I think checking the configuration of the system is a good start point to resolve it.

 

Thanks

 

0 Kudos
Message 2 of 4
(248 Views)
Highlighted

Hi Chan82,

 

Thanks for your response. ๐Ÿ™‚ I checked installed software series from MAX compare with other RTs, but couldn't find any specific weird one. I guess this is not the root cause right now. 

Thanks for your comments anyway.

Best Regards,
-----------------------------------------------------------------------------------------------------------

There are only two ways to tell somebody thanks: Kudos and Marked Solutions
0 Kudos
Message 3 of 4
(241 Views)

Hello,

 

This is a description of error 66464.

 

The global time on the controller was altered, which might affect the period of an iteration of the NI Scan Engine. A timing source such as IEEE-1588 or GPS modified the global time value on the controller. This can result in a temporary phase shift, which would alter the update period for NI Scan Engine variables for one iteration.

 

Please check the time of the controller time.

 

Regards

0 Kudos
Message 4 of 4
(226 Views)