Power Electronics Development Center

Reply
This is an open group. Sign in and click the "Join Group" button to become a group member and start posting.

multisim and labview based problem

hello,

please tell me the cause of error that is ''launching multisim was unsuccessful', in my boost converter circuit model which is designed on multisim 12 and fetched to labview. as soon as execution of the model start it pops up error message as stated above.

this same circuit was working before properly, now it started showing this error

aditya

0 Kudos
Message 1 of 3
(4,510 Views)
2 REPLIES
Highlighted

Re: multisim and labview based problem

Hi there,

Since this was working before, did something change on your PC?

Try running an example from the Multisim Samples folder. In Multisim go to File>>Open Samples>>LabVIEW-Multisim Co-simulation>>Boost Converter.

In the Boost Converter folder you will find a VI and a circuit. Run the VI to see if LabVIEW communicates with Multisim.

What's your exact Multisim version (go to Help>>About Multisim)?

LabVIEW Version?

Regards,

Fernando D.
National Instruments

0 Kudos
Message 2 of 3
(3,924 Views)

Re: multisim and labview based problem

On my PC, windows10, Labview2017, Mutlsim 14.1, run the summer.vi under the LabVIEW-Multisim Co-simulation folder, I have got error message:

 

Error -2367 occurred at External Model in summer.vi/Control & Simulation Loop

Possible reason(s):

Control Design and Simulation: The shared library corresponding to the external model returned an error.

Launching Multisim was unsuccessful. (L404)

 

Any suggestions?

Thanks in Advance

Adam

0 Kudos
Message 3 of 3
(2,629 Views)
Reply
This is an open group. Sign in and click the "Join Group" button to become a group member and start posting.