Power Electronics Development Center

cancel
Showing results for 
Search instead for 
Did you mean: 

Error -2367 occurred at External Model in VSC_Control.vi/Control & Simulation Loop

Dear all,

I am very new to Labview programming. I try to simulate a two-level three-phase VSC using Multisim co-simulation with Labview. I modeled the plant and control system in Multisim and Labview, respectively. However, when I want to run te model I get the following error! 

 

Error -2367 occurred at External Model in VSC_Control.vi/Control & Simulation Loop

Possible reason(s):

Control Design and Simulation: The shared library corresponding to the external model returned an error.

Launching Multisim was unsuccessful. (L404)

 

I would be very grateful if you could address this error! Thanks for your time!

0 Kudos
Message 1 of 3
(4,366 Views)

Hi,

 

If you could share with us the whole project, it would be easier to help you.

If it is not possible from your side, we can discuss some details via email.

 

kind regards,

$

0 Kudos
Message 2 of 3
(4,354 Views)

@HoomanGh wrote:

Dear all,

I am very new to Labview programming. I try to simulate a two-level three-phase VSC using Multisim co-simulation with Labview. I modeled the plant and control system in Multisim and Labview, respectively. However, when I want to run te model I get the following error! 

 

Error -2367 occurred at External Model in VSC_Control.vi/Control & Simulation Loop

Possible reason(s):

Control Design and Simulation: The shared library corresponding to the external model returned an error.

Launching Multisim was unsuccessful. (L404)

 

I would be very grateful if you could address this error! Thanks for your time!


 

0 Kudos
Message 3 of 3
(3,911 Views)