From 11:00 PM CST Friday, Feb 14th - 6:30 PM CST Saturday, Feb 15th, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

PXI

cancel
Showing results for 
Search instead for 
Did you mean: 

Is nobody use a PXI-6052E to acquire scan at low frequency ?? When I try to create a scan of two samples per scan (sample scan at 100hz) the ScanStart function return -10697 (rateNotSupportedError)!

The frequency parameter given to the ScanStart function are the followings:
- sample base = -1 (200ns)
- sample interval = 22 727
- scan base = 1 (1?s)
- scan interval = 10 000
This parameters should work but there is a problem.
If you had an explanation...
Thank you
0 Kudos
Message 1 of 3
(3,967 Views)
Brice;

You are getting that error because the E-series boards only support either 100KHz or 2MHz Timebases.

Double check the NI-DAQ on line reference manual to see the proper parameter to the ScanStart function that represents one of the two timebases above.

Hope this helps.
Filipe A.
Applications Engineer
National Instruments
Message 2 of 3
(3,967 Views)
It is totaly right, I had a bad version of the NI-DAQ reference manual !
Thank you
0 Kudos
Message 3 of 3
(3,967 Views)