NI VeriStand

Showing results for 
Search instead for 
Did you mean: 

Max value reset


I am trying to keep track of a max value over a variable interval of time. The easiest way I can think of to this would be to use a calculated channel that compares itself to the channel I am checking and keeps whichever is higher. However, I want to be able to reset that channel without having to redeploy.


There does not seem to be any way to reset a maximum calculated channel. Anyone know of a good way to force a reset on that?

0 Kudos
Message 1 of 4

Is your reset based on a value, or some other stimulus? If it's based on a value, you could use the Peak and Valley function and set the reset value. 


You also might use a combination of alarms and procedures to check for the reset request and then work from that--I'm not sure there's a way to force this easily.

Claire M.
Technical Support
National Instruments
Certified LabVIEW Developer
0 Kudos
Message 2 of 4

When I developed in the past, I created Custom Device to hold max value.

It could reset the stored value with some way.


But as Claire mentioned, I agree using procedure is good way.


Why don't you "Set Variable" procedure?

Certified LabVIEW Developer
There are only two ways to tell somebody thanks: Kudos and Marked Solutions
0 Kudos
Message 3 of 4

A LabVIEW model is the most reasonable solution here.  Write an FGV that retains the maximum value returned by one of its inputs and include a "Reset" state that sets the value back to zero or whatever is appropriate.  


Once you've compiled the model, use a system mapping to link up the input channel you're interested in getting the maximum value for.  


If you're unfamiliar with the process of creating/importing LabVIEW models, this white paper gives a good walkthrough. 



Matt | NI Systems Engineering
0 Kudos
Message 4 of 4