NI TestStand

cancel
Showing results for 
Search instead for 
Did you mean: 

test report numeric format

Solved!
Go to solution
Highlighted

How  do or can I set the numeric format, decimal places, of the TS v16 Test Report. Using Labview 2016 module to perform Multiple Numeric Test. The Measurement, High, Low Limit are read via 2D double array into TS.

 

TestStand report appears to show 3 decimal places. I only need to show 1 or 2 decimal places for measurements and limits.

0 Kudos
Message 1 of 3
(82 Views)
Solution
Accepted by topic author richjoh
07-11-2019 01:49 PM

It probably depends on how the report generator you are using was written.  If it is using the Get Formatted Value method, then you just have to set the format where you define your limits.


There are only two ways to tell somebody thanks: Kudos and Marked Solutions
Unofficial Forum Rules and Guidelines
Message 2 of 3
(80 Views)

Thanks, I overlooked that format menu. Selected "Custom", Real number and 2 decimal places..

0 Kudos
Message 3 of 3
(57 Views)